Document Type : Regular Paper
Authors
1
Ph.D. Student, Faculty of Civil Engineering, Semnan University, Semnan, Iran
2
Assistant Professor, Faculty of Civil Engineering, Semnan University, Semnan, Iran
3
Professor, Faculty of Civil Engineering, Semnan University, Semnan, Iran
10.22075/jrce.2026.2757
Abstract
Warm Mix Asphalt (WMA) technologies can reduce production temperatures, but modifier combinations must maintain adequate binder performance across service temperatures. This study evaluates a hybrid binder based on a PG 64-22 base bitumen containing 3% Sasobit and co-varying Zycotherm/nano-silica dosages of 0.05/0.5, 0.10/1.0, 0.15/1.5, and 0.20/2.0% by binder mass (Types A-D). Conventional tests, Dynamic Shear Rheometer (DSR) testing, and Bending Beam Rheometer (BBR) testing were conducted on unaged and aged binders using the aging conditions reported in the experimental program. Increasing the hybrid-modifier level raised the softening point from about 51.4 to 61.6 °C and reduced penetration from about 65 to 53.8 (0.1 mm), indicating progressive stiffening. The DSR results showed higher G*/sinδ values for the modified binders at the tested high temperatures, while the RTFO-aged results also exhibited the expected aging-induced stiffening. BBR results show an important low-temperature limitation: the binders satisfy the creep stiffness values, S≤300 MPa and the creep rate change values, m≥0.300 criteria at -12°C, but the plotted m-values are below 0.300 at -18°C and both stiffness and m-value criteria are not satisfied at -24°C. Thus, the measured evidence supports improved high-temperature rutting-related rheology but does not demonstrate improved aging resistance, moisture resistance, mixture workability, or fatigue performance. Because Zycotherm and nano-silica were increased simultaneously, the contribution of each individual modifier cannot be separated from the present experimental matrix.
Keywords
Subjects